Husqvarna K6500 Ring Workshop Manual page 15

1 2
4 5
7
8
REPLACING ROLLER BEARINGS
Remove the bearing unit
Secure the bearing press in a vice.
Place the removal sleeve with the shoulder up and turn the bearing arm so
that the tool screw meets the bearing arm screw.
Press out the bearing unit from the bearing arm.
Knock the shaft out from the bearings in the same way as shown on page 13.
Fit new bearings
3
1. Place the shaft with the flange facing the hole in the bearing press. Add a
ball bearing and place the mounting device on the bearing. Press down the
bearing until the device is in contact with the shaft.
2. Add the inner and outer spacer rings.
3. Add the next ball bearing and place the mounting device on the bearing.
4. Press down the entire bearing unit until it touches the shaft flange.
6
5. Grease the O-ring on the screw and fit this in the bearing arm.
6. Turn the bearing arm with the screw through the hole in the tool. Press in
the bearing unit until it touches bearing arm.
9
10
! 7. Fit the circlip. Fit the wear ring with
the bevel outwards, as per the illustra-
tion. Fill the new radial seal internally
with grease and fit using the mounting
device. Add the cover washer.
8. Fit the sealing collar using the tool's
removal sleeve. First fit the mounting
device on the shaft to centre the sleeve,
now turn the sleeve.
Create a bridge with a suitable object
on the sleeve and press on the sealing
collar.
9. Apply grease to the seal and mount the
cover washer. Grease the support roller
seat.
10. Fit the bearing arm in the cover.
8
15