Summary of Contents for ICP DAS USA iWSN-9601 Series
Page 1
Series Quick Start v1.0, Sep. 2023 Packing List In addition to this guide, the package includes the following items iWSN-9601 Screw Split 4 M4*16L Series driver Core CT Mounting Screws Model Name Split Core CTs iWSN-9601-□□□-ME-IP33 (□□□: 160, 240, 360)
1. Appearance Descriptions LED panel cover. The LEDs statuses are shown here. Loosening two screws and opening the cover can configure the module by the DIP switches and trigger button. The screws for LED panel cover. Connector protector. Loosening two screws and open the protector can wire the CTs and voltage input cables into the module.
Page 3
3. DIP switch & trigger button Definitions Descriptions L Switch for configuring the RF channel, Tx period and AC wiring types. R Switch for configuring the Node ID, RF group ID and the PA function. Trigger button for forcing to transmit data once. Holding it 5 seconds will reset the module.
4. Pin assignments CT input connector. CT_0/1/2/3/4/5 is used for 6 single-phase current measurements. The terminal labeled W is for connection to the CT white (or red) wire and the terminal labeled B is for connection to the CT black wire. AC voltage input connector.
The iWSN-9601 series modules can only be used with the specific CTs. Only the model name iWSN-9601-PCT-ME-IP33 doesn’t include CTs. Please check the accessories of the product website or contact to the ICP DAS distributor to purchase the CTs for this model if necessary.
3. Turn ON the iWSN-200U/E and iWSN-9601 series module to start the data collection. The RF_Rx LED of the iWSN-200U/E flashing once indicates the iWSN-200U/E has received one message from the iWSN-9601 series module. 1. The flash of RF_Rx LED indicates...
Page 8
Power Consumption Input Type Single phase 58 - 277 VAC Includes CTs 0 (*Note) CT Type Split core CT Max. Current Depended on the selection -160: Max. 100 A (Max. 400 A) -240: Max. 200 A -360: Max. 400 A Inside Diameter Depended on the selection -160: 16 mm...
Caution 1. Danger The meter contains hazardous voltages, and should never be disassembled. Failing to follow this practice will result in serious injury or death. Any work on or near energized meters, meter sockets, or other metering equipment could induce a danger of electrical shock. It is strongly recommended that all work should be performed only by qualified industrial electricians and metering specialist.
Need help?
Do you have a question about the iWSN-9601 Series and is the answer not in the manual?
Questions and answers