A&D UA-1200CNBLE Instruction Manual page 13

USING THE MONITOR
Wireless Function
† In the unlikely event that this monitor causes radio wave
interference to a different wireless station, change the
location where this monitor is used or stop use immediately.
† Be sure to use in a location where visibility between the two
devices that you want to connect is good. The connection
distance is reduced by the structure of buildings or other
obstructions. In particular, connection may be impossible
when devices are used on either side of reinforced concrete.
† Do not use the Bluetooth
wireless LAN or other wireless devices, near devices that
emit radio waves such as microwaves, in locations where
there are many obstructions, or in other locations where
signal strength is weak. Doing so may result in frequent loss
of connection, very slow communication speeds and errors.
† Using close to an IEEE802.11g/b/n wireless LAN device
may cause mutual interference to occur, which may result
in reduced communication speeds or which may prevent
connection. In this case, switch off the power supply to
the device that is not being used, or use the monitor in a
different location.
† If the monitor does not connect normally when used near
a wireless station or broadcast station, use the monitor in
a different location.
† A&D Medical cannot accept liability for any damages
incurred due to impaired operation or data loss, etc. that
occur through the use of this product.
† This product is not guaranteed to connect to all Bluetooth
compatible devices.
connection in the range of a
®
®
E-13