Hyundai HYTC150-2 User Manual page 18

REMOVING ROOTS
Make sure the throttle is set to high speed, the cutter wheel will accelerate to cutting speed
Swing the cutting wheel to one side, then lower it into the nearest roots that are buried at the foot
of the stump.
Swing the cutting wheel before each sweep, until the roots are sufficiently removed.
Raise the cutting wheel until the center of the cutting wheel is just above the top of the stump.
Allow the cutter wheel to stop, release the brake and reposition the machine.
Lock the brake again.
CUTTING THE FULL STUMP
Make sure the throttle is set to high speed. The cutter wheel will accelerate to cutting speed
Direct the cutter wheel against the stump, beginning with the nearest top corner of the stump, and
steadily sweep it across the stump left and right, cutting away 1/2 inch/ 13mm of wood with each
sweep.
Raise and lower the cutter wheel between sweeps by lowering and raising the control handle.
18