Related Manuals for Hyundai HM600BMC
Summary of Contents for Hyundai HM600BMC
- Page 1 125MM ANGLE GRINDER HM600BMC INSTRUCTION MANUAL Please keep this instruction manual for future reference...
- Page 2 Table of Contents Section Page Declaration of conformity Product specification Power tool safety instructions 3 & 4 Know your angle grinder Controls and operation Fitting grinding disc Carton contents General information Symbols Electrical information Parts Drawing Parts list Accessories. 1 - 4 ½”/115mm Grinding Disc. 1 - 4 ½”/115mm Cutting Disc 1 - 4 ½”/115mm Diamond cutting disc for masonry...
- Page 3 CAUTION. Carefully read through this entire instruction manual before using your new power tool. Take special care to heed the Cautions and Warnings TECHNICAL DATA We have made every effort to ensure accuracy of information in this manual at time of going to print. Specification 4 1/2”/115mm Angle grinder...
- Page 4 SAFETY INSTRUCTIONS To use this tool properly, you must observe the safety regulations, the assembly instructions and the operating instructions to be found in this manual. All persons who use and service the machine have to be acquainted with this manual and must be informed about any potential hazards. Children and infirm people must not use this tool.
- Page 5 18. tool to the power supply. Do not carry a plugged in tool. 19. with your finger on the switch . When a tool is used outdoors, use only extension cords that Use outdoor rated extension cords are intended for outdoor use and are so marked. .
- Page 6 Page 4 • Do not secure the angle grinder in a vice or work bench and use it as a static grinder. It leads to serious injury. • Never apply excessive pressure to the disc it might shatter causing personal injury. •...
- Page 7 CONTROLS 1/ Looking at the angle grinder from the top, the spindle lock (2) is located at the front top right hand side. 2/ There are attachment points (4) for the handle (6) at either side of the front of the housing, Attach the handle in the position that suits the planned operation.
- Page 8 Page 6 FITTING A GRINDING DISC Caution. Switch off the grinder and disconnect 8/ Place the grinding disc onto the spindle with it from the power point label facing the angle grinder. The hole in the disc 1/ Turn the angle grinder should locate onto the on to its back and spindle and fit firmly...
- Page 9 GENERAL INFORMATION FITTING A CUTTING DISC 1/ Use the same procedure as for the grinding disc except use the outer flange the other way round. The spigot section should face away from the disc. WARNING Do not immerse the disc into any type of lubrication including water. This angle grinder is designed as a dry grinder/cutter/polisher.
- Page 10 SYMBOLS WARNING Some of the following symbols may be used on the tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer. Speed of normal load no load speed volts amperes...
- Page 11 PARTS DIAGRAM Page10...
- Page 12 PARTS LIST Page11...