Attach The Optical Network Cable - Cisco Nexus 9808 NX-OS Hardware Installation Manual

Attach the Optical Network Cable

Figure 44: Installing the QSFP Transceiver Module
Step 6 Press firmly on the front of the transceiver module with your thumb to fully seat the transceiver in the module's
transceiver socket (see the below figure).
Caution
Figure 45: Seating the QSFP Transceiver Module
Attach the Optical Network Cable
Before you begin
Before you remove the dust plugs and make any optical connections, follow these guidelines:
• Keep the protective dust plugs installed in the unplugged fiber-optic cable connectors and in the transceiver
• Inspect and clean the optical connector end faces just before you make any connections.
Cisco Nexus 9808 NX-OS Mode Switch Hardware Installation Guide
56
If the latch isn't fully engaged, you might accidentally disconnect the transceiver module.
optical bores until you are ready to make a connection.
Connect Switch to the Network