Notice Upon Installation Of Product - GE LOGIQ C5 Quick Manual

LOGIQ C5/C5 PRO Quick Guide
EMC (Electromagnetic Compatibility) (continued)
Portable and mobile radio communications equipment (e.g. two-way radio, cellular/cordless telephones, and similar equipment) should be used no closer to any part
of this system, including cables, than determined according to the following method:
Frequency Range:
Calculation Method:
Where: d= separation distance in meters, P = rated power of the transmitter, V
If the maximum transmitter power in
watts is rated
5
20
100

Notice upon Installation of Product

Separation distance and effect from fixed radio communications equipment: field strengths from fixed transmitters, such as base stations for radio (cellular/cordless)
telephones and land mobile radios, amateur radio, AM and FM radio broadcast, and TV broadcast transmitter cannot be predicted theoretically with accuracy. To
assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in the
location in which the ultrasound system is used exceeds the applicable RF compliance level as stated in the immunity declaration, the ultrasound system should be
observed to verify normal operation. If abnormal operation is observed, additional measures may be necessary, such as re-orienting or relocating the ultrasound
system or using an RF shielded examination room may be necessary.
1. Use either power supply cords provided by GE Medical Systems or ones designated by GE Medical Systems. Products equipped with a power source plug
should be plugged into the fixed power socket which has the protective grounding conductor. Never use any adaptor or converter to connect with a power
source plug (i.e. three-prong-to-two-prong converter).
2. Locate the equipment as far away as possible from other electronic equipment.
3. Be sure to use only the cables provided by or designated by GE Medical Systems. Connect these cables following the installation procedures (i.e. wire power
cables separately from signal cables).
4. Lay out the main equipment and other peripherals following the installation procedures described in the Option Installation manuals.
Direction 5272220-100 Rev. 2
Table 9: Portable and mobile radio communications equipment distance requirements
150 kHz - 80 MHz
d=[3.5/V ] square root of P
1
=compliance value for conducted RF, E
1
2.6
5.2
12.0
80 MHz - 800 MHz
d = [3.5/E ] square root of P
1
= compliance value for radiated RF
1
The separation distance in meters should be
2.6
5.2
12.0
800 MHz - 2.5 GHz
d = [7/E ] square root of P
1
5.2
10.5
24.0
39