Operation; Control Panel - Gastrodomus GA200PR Installation, Operating And Service Instructions

Installation
Note: If the unit has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt let it stand.
Remove the appliance from the packaging and the protective film from all surfaces.
1.
Avoid positioning the appliance in direct sunlight or damp areas.
2.
Insert the slide-out shelf/shelves at the desired levels and place the smaller shelf/shelves on the
3.
floor of the appliance.
Note: Before using the appliance for the first time, clean the shelves and
interior with a humid sponge and neutral detergent, then carefully dry them.
DANGER! Electrical Shock Hazard risk!
The appliance should be connected only to an interlocked socket protected
against indirect contact in compliance with the rules in force in the reference
country. Please do not unplug the equipment by pulling it from the cable.
Do not make the power cable touch any heat sources.
Do not spray water on the equipment and do not expose it to rain, water or some other
source of moisture.
An improperly installed appliance could lead to serious injuries. Before installing the
equipment, please compare the local power grids with those of the appliance (see the
technical data plate on the back of the device). The device may be connected to the power
only if the technical data corresponds to those on the plate! Please follow all the safety
regulations!

Operation

Control Panel

The control panel is located below the doors on the front of the appliance (see fig. 1, page 25).
Turn On
1. Close the door of the appliance.
Connect the appliance to a mains power supply.
2.
Turn on the main switch.
3.
Use the right switch to turn on and off the internal light.
4.
Note: The Cooling Light
compressor has started.
3
TRANSLATION FROM THE ORIGINAL
is lit when the refrigeration unit is working and the
- 3 -