Troubleshooting - Gastrodomus GA200PR Installation, Operating And Service Instructions

Troubleshooting

If your appliance develops a fault, please check the following table before calling the service dept. of
your authorized distributor:
Fault
The appliance is not
working
The appliance turns
on, but the
temperature is too
high.
The appliance is
unusually loud
Disposal
At the end of the life of the equipment, you must dispose of it, according to the current local and
national rules.
The device contains electrical and electronic components called "Waste Electrical and Electronic
Equipment" (WEEE).
5
TRANSLATION FROM THE ORIGINAL
Possible cause
The unit is not
switched on
Plug or wire are
damaged
A fuse in the socket
has blown
No power
Internal wiring fault
Condenser blocked
with dust
The door is not
properly shut
The appliance is
located near a heat
source or the airflow
to the condenser is
being blocked
Ambient temperature
is too high
Insufficient airflow to
the fans
Appliance is
overloaded
The factory default
parameters have been
changed
The appliance is
touching a
neighbouring object
The appliance has not
been installed in a
level or stable position
Check if the unit has been correctly plugged in
and switched on
Call the distributor or a qualified service
technician
Check and in case replace the fuse
Check the power supply
Call the distributor or a qualified service
technician
Clean the condenser
Check that the door closes and the seal is not
damaged
Move the appliance to a more suitable location
Increase the room's ventilation or move the
appliance to a cooler location
Remove any object that blocks the correct air
circulation
Reduce the products amount stored in the
appliance
Call the distributor or a qualified service
technician
Check the installation position and move the
appliance if necessary
Check the installation position and make sure
the appliance is into a stable position and in
level.
Action
- 5 -