Toro 33518 Operator's Manual page 50

Figure 60
Left transmission shown
1. Sight plug
2. Sight-plug port
Figure 61
Left transmission shown
1. Sight plug
2. Sight-plug port
3. At the inboard side of the transmission, near
the top, remove the sight plug from 1 of the
transmissions (Figure 60
4. Add the specified fluid to the expansion tank
until fluid flows from the sight-plug port; refer to
Checking the Transmission Fluid Level (page
48).
5. Install the sight plug and torque it to 244 N∙m
(180 in-lb).
6. Repeat steps 3 through
transmission.
7. Add the specified fluid into the expansion tank
until the fluid level is at the Full Cold line of the
tank.
g026015
3. Up
g026016
3. Up
and Figure 61).
5 for the other
8. Start the engine and move the throttle midway
between the S
9. Disengage the parking brake.
10. Slowly move the motion-control levers in the
forward and reverse directions 5 to 6 times.
Note:
Cycling the traction-controls forward and
reverse purges air from the transmissions.
11. Shut off the engine and remove the key.
12. Check the fluid level in the expansion tank,
and add the specified fluid as required; refer to
Checking the Transmission Fluid Level (page
48).
13. Repeat steps
completely purged from the transmissions.
Note:
The air is purged when the transmissions
when the transmissions operate at normal noise
levels and smoothly move forward and reverse
at normal speeds.
14. Lower the machine and remove the jack stands.
50
and F positions
LOW AST
8 through 12 until all the air is