Servicing The Engine Oil - Toro 33518 Operator's Manual

Installing the Foam and Paper
Elements
Important:
To prevent engine damage, always
operate the engine with the complete foam and
paper air-cleaner assembly installed.
1. Carefully slide the foam element onto the paper
air-cleaner element
2. Align the air-cleaner assembly onto the inlet duct
and secure it with the hose clamp
3. Align the air-cleaner cover onto engine cover
and secure the cover by rotating the cover knobs
1/4 turn clockwise

Servicing the Engine Oil

Oil Type: Detergent oil (API service SJ or later)
Engine Oil Capacity: 1.7 L (1.8 US qt) with the filter
removed; 1.5 L (1.6 US qt) without the filter removed
Oil viscosity: Refer to the table below.
Figure 31
Changing the Engine Oil
Note:
Dispose of the used oil at a recycling center.
1. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil
drains completely.
2. Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Change the engine oil as shown in
Note:
Torque drain plug to 27 to 33 N∙m (20
to 24 ft-lb).
(Figure 30).
(Figure
(Figure 30).
Figure
30).
g004216
4. Slowly pour approximately 80% of the specified
oil into the filler tube, and slowly add the
additional oil to bring it to the Full mark
34).
33.
34
Figure 32
Figure 33
g025980
g025979
(Figure