Sealey CST983.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
Always load evenly with the centre of gravity of the load as near the centre and rear of the plate as possible.
9
Obtain additional support for large or wide loads to prevent tipping.
9
DO NOT overload the truck - see Specification.
8
DO NOT leave unattended, especially when loaded, unless the wheels are chocked or the truck is otherwise secured.
8
DO NOT use truck on uneven ground and do not run over curbs or steps - use a ramp.
8
DO NOT allow others to ride on the truck.
8
DO NOT use the truck if any part is damaged, paying particular attention to the wheels.
8
2. INTRODUCTION
Strong tubular steel construction with welded joints. Heavy-duty wheels feature steel inserts for added
strength and durability. Can be rested on handles for flat loading. Fitted with rubber handgrips.
3. SPECIFICATION
Model No:
Capacity:
Height(s):
Overall Width:
Platform Depth:
Wheel Size:
Wheel Width:
4. ASSEMBLY
4.1. WHEELS
4.1.1. Ensure axle is clean from dust and dirt to allow free movement of the wheel.
4.1.2. For Model No's. CST987.V2 and CST988.V3 the axle (fig.1.1) needs to be put through the frame before the wheels can be attached.
4.1.3. Slide the wheel (fig.1.2) onto the axle, put on the washer (fig.1.3) and complete by pushing the split pin (fig.1.4) through the hole in the end of
the axle and bending over to retain.
4.1.4. Repeat for the other side.
fig.1
5. FEATURES
5.1. Model CST983.V2 has solid tyres whilst Models CST986.V2, CST987.V2, & CST988.V3 have pneumatic tyres.
5.2. CST983 can be rested on its handles for flat loading.
5.3. CST988 is a case carrying model with a high back, 'P' handle and flat loading capabilities.
© Jack Sealey Limited
SACK TRUCKS
MODEL NO'S:
CST988.V3
CST983.V2 CST986.V2
150kg 200kg
1170mm 1100mm
460mm 550mm
220mm 180mm
Ø210mm Ø250mm
50mm 90mm
Original Language Version
CST983.V2, CST986.V2, CST987.V2,
CST987.V2 CST988.V3
200kg 250kg
1190mm 1260mm
545mm 560mm
255mm 220mm
Ø250mm Ø250mm
90mm 90mm
CST983.V2 CST986.V2 CST987.V2 CST988.V3 Issue 3 (H,3,F) 28/06/23