Connecting An External Monitor - Sharp PG-D210U Operation Manual

4
IN 2
1
5
IN 1
OUT
Direct
connection
External IBM-PC
monitor
E-17
COMPUTER AUDIO
IN 1 IN 2
AUDIO WIRED
OUTPUT REMOTE
PC CONTROL
2
COMPUTER RGB
IN 2
Optional Macintosh
adaptor cable
U.S.A. ONLY
or
External Macintosh
monitor
3. Connecting to other compatible
computers
When connecting the projector to a compatible computer
other than an IBM-PC (VGA/SVGA/XGA/SXGA) or
Macintosh series, a separate cable may be needed.
Please contact your dealer for ordering information.
Notes:
• Connecting computers other than the recommended types may
result in damage to the projector, the computer, or both.
• Connect the audio from the computer to the COMPUTER AUDIO
INPUT terminal.
4. Connecting to the COMPUTER AUDIO
INPUT
• The COMPUTER AUDIO INPUT 1 accepts audio from
the COMPUTER RGB 1 input, and the COMPUTER
AUDIO INPUT 2 accepts audio from the COMPUTER
RGB 2 input.
• Connect a 3.5 mm Stereo Minijack cable from the
audio output terminal on the computer to the
COMPUTER AUDIO INPUT terminal on the projector.

5. Connecting an external monitor

Connect your computer monitor to the projector's COM-
PUTER RGB OUTPUT terminal to view images simulta-
neously on the external monitor and the projection
screen. Select either RGB 1 or RGB 2 to output the
images to the monitor.
Caution (Apple Macintosh):
Do not connect the COMPUTER RGB OUTPUT to any moni-
tor except the following:
Apple Color RGB Monitor 13 /14 (640
624) or 19 (1,024 768)
The output signal from the projector to the monitor should be
the same as the input signal from the computer to the
projector.
Examples:
Input 13 /14 (640
Input 16 /17 (832
Input 19 (1,024 768)
Note:
• The supplied adaptor is only for use with H-SYNC and V-SYNC
output. No picture will appear when connected to monitors that
only use C-SYNC.
Notes:
• When using the projector with an external IBM-PC monitor, connect
the monitor using the supplied cable. When using the projector with a
Macintosh monitor, an optional adaptor cable is required. Before
using any other type of monitor, carefully check the monitor's inter-
face specifications and make sure that they match the specifications
of the projector's interface.
• The external monitor output will only display an analog computer
input signal. It will not display a digital or video input signal. To split
the composite video signal, use a video distribution amplifier. This is
available from your local dealer. The computer RGB output will only
loop through the same signal connected to the computer RGB input.
(VGA IN VGA OUT, Mac IN
480), 16 /17 (832
480) Output (640 480)
624) Output (832 624)
Output (1,024 768)
Mac OUT)