Inserting And Removing A Smartmedia Card - Sharp Internet ViewCam VN-EZ1U Operation Manual

Preparations
Inserting and Removing a
SmartMedia Card
This Digital Recorder uses a SmartMedia card for memory. It
will retain recorded images even if the batteries are depleted
or the power source is interrupted.
Inserting a SmartMedia Card
1
Make sure the power of the Digital Recorder is
turned off.
2
Slide the battery compartment cover (1) to open it
in the direction of the arrow (2).
2
3
Insert a SmartMedia card in the direction of the
arrow and push it in as far as it will go.
Make sure that the Contact area is facing up and that
you insert the end with a chipped corner into the slot.
Contact area
17
1
Chipped corner
4
Close the battery compartment cover (1), hold
down the cover (2) and slide it in the direction of
the arrow (3) until it clicks.
1
Note:
• Press and slide the battery cover until it is closed securely, or
the batteries push up the cover.
Removing a SmartMedia card
Pull out the SmartMedia card in step 3 above.
Notes:
• Be careful not to drop the batteries when opening the battery
compartment cover.
• Do not use a 5 V SmartMedia card. Use the supplied
SmartMedia card or a commercially available card, which is
3.3 V type.
2
3