Warning Indicators - Sharp Internet ViewCam VN-EZ1U Operation Manual

Mpeg-4 digital recorder
Hide thumbs Also See for Internet ViewCam VN-EZ1U:
Table of Contents

Advertisement

Important Information

Warning Indicators

CLOCK SET
You have not yet set the built-in clock.
POWER OFF
The batteries are almost dead.
NO CARD
The SmartMedia card is not loaded
properly. Make sure that the correct side
of the card is facing up and insert the
correct end of the card into the slot.
NO FILE
The SmartMedia card has no
images recorded in the format the
Digital Recorder can recognise.
CARD FULL
The SmartMedia card's capacity is
insufficient. Delete unnecessary
images from the card or replace
the card with new one.
FILE NO. FULL
The Digital Recorder has used up
all the assignable image numbers
for file names. Delete unnecessary
images from the card or replace
the card with capacity.
CARD ERROR
The image files in the SmartMedia
card is corrupted or is recorded in
a format which is not compatible
with the Digital Recorder. Copy the
necessary images in your
computer's hard disk and reformat
the SmartMedia card.
NOT INITIALIZED
The SmartMedia card is not formatted.
PROTECTED CARD The SmartMedia card is protected.
Remove the Write-protect seal.
13
PROTECTED
You are trying to delete a protected
image. Unprotect it before deletion.
READ ERROR
Can not read the images in the
SmartMedia card. The Digital
Recorder possibly cannot play
back the images recorded by
another digital cameras.
Make backup copies of images on
other media, if necessary. And then
format the SmartMedia card.
WRITE ERROR
Cannot record the images on the
SmartMedia card. Check that the
battery power is sufficient and the
SmartMedia card is loaded properly.
AUTO POWER OFF The power will be turned off about
five seconds later. To turn it on
again, slide the POWER switch.
BUSY
Now processing instructions. Wait
until this indicator disappears.
TEMP ERROR
The Digital Recorder becomes
warm to touch. Turn off the power
and do not use for a while.
CAN'T REC
Cannot record the images in the
Time-lapse Movie mode because
the recording time is too short. For
" 100" mode, recording time
should be more than 10 sec.
CAN'T DIVIDE
Cannot divide the movie.

Advertisement

Table of Contents
loading

Table of Contents