Table of Contents
Advertisement
172 A.3.Lb.
Alarm 3 Label
Selects the message displayed in case of alarm 3 intervention.
Disabled. (Default) 0.
disab.
Message 1 (see table on paragraph 13.1) ...
lb. 01
Message 20 (see table on paragraph 13.1)
lb. 20
Custom message (modifiable by the user through the App or via modbus)
user.l.
173÷176
Reserved Parameters - Group I
Reserved parameters - Group I
GROUP J -
AL. 4
177 AL. 4 .f.
Alarm 4 Function
Alarm 4 selection.
Disabled (Default)
diSab.
Absolute Upper Activation. Absolute referred to the process, active over
Ab.up .A.
Absolute Lower Activation. Absolute referred to the process, active under
Ab.Lo.a.
Band alarm (command setpoint ± alarm setpoint)
bAnd
Upper Deviation alarm
up .dev .
Lower Deviation alarm
Lo.dev .
Absolute Command Upper Activation. Absolute alarm referred to the command
Ab.c.u.A.
setpoint, active over
Absolute Command Lower Activation. Absolute alarm referred to the command
Ab.c.L.A.
setpoint, active under.
Status alarm (active in RUN/START)
run
Cold actuator auxiliary (Cold action in double loop)
cooL
Probe error. Alarm active in case of sensor rupture.
Prb.er.
Related to timer 1
tMr.1
Related to timer 2
tMr.2
Related to both timers
tMr.1.2
Remote. The alarm is enabled by the word 1238
rEM.
Digital Input 1. Active when digital input 1 is active.
d.i. 1
Digital Input 2. Active when digital input 2 is active.
d.i. 2
Heater Break Alarm and Overcurrent Alarm
H.b.A.
Asymmetric band alarm (command setpoint + alarm setpoint 4 H and command
a.bAnd
setpoint - alarm setpoint 4 L).
Auxiliary for job distribution on the command output. It cyclically replaces the
c. aux
command output for the time set on the parameter 188
activated parallel to the command output. It does not work in case of valve control and
can only be activated on an alarm if
178 rEs.
Reserved
Reserved parameter
179 rEs.
Reserved
Reserved parameter
180 A. 4 .5.o.
Alarm 4 State Output
Alarm 4 output contact and intervention type.
(N.O. Start) Normally open, active at start (Default)
n.o. St.
(N.C. Start) Normally closed, active at start
n.c. St.
(N.O. Threshold) Normally open, active on reaching alarm
n.o. tH.
(N.C. Threshold) Normally closed, active on reaching alarm
n.c. tH.
(N.O. Threshold Variation) disabled after changing control setpoint
n.o.tH.V .
(N.C. Threshold Variation) disabled after changing control setpoint
n.c.tH.V .
40 - URDR001A - User manual
- Alarm 4
is different from 0.
A. 4.de.
. If
A. 4.de.
A. 4.de.
2 p. 54
2 p. 54
3 p. 54
3 p. 54
= 0, it is
Advertisement
Table of Contents
