Table of Contents
Advertisement
Packing for Storage or Transportation
To store the ADTS or to return it for calibration or repair carry out the following procedures:
1)
The ADTS should be at zero/ambient pressure. Disconnect the hose assemblies and stow in the
accessory bag.
2)
Switch OFF and disconnect from the electrical power supply.
3)
Close and latch the lid to the ADTS.
4)
The power supply cable should be placed in the original packing material.
5)
Place the ADTS in the original special packing box or appropriate transport container.
6)
Mark carton "FRAGILE" on all sides, top, and bottom of the container.
7)
The battery (Lithium based) must be removed from the ADTS Touch during transportation. If
shipping an ADTS Touch and/or battery unit please contact your local service centre beforehand
for shipping requirements.
8)
To return the ADTS for calibration or repair complete the return goods procedure as detailed in
Returned Goods Procedure section.
Environment
: Items in storage are defined as being non-operational
NOTE
The following conditions apply for both shipping and storage:
Store in a cool dry place
Storage Temperature Range
Storage Altitude
If the ADTS becomes exposed to moisture or very high humidity, dry as soon as possible and tempo-
rarily store in a low humidity area.
: It is important that the customer be sure the ADTS is in compliance with the OEM re-certifica-
NOTE
tion.
-
ADTS542F: -20°C to 70°C (-4°F to 158°F)
ADTS552/553/554F: -30°C to 70°C (-22°F to 158°F)
ADTS Touch Battery:
Short Term (e.g. during Shipping ) : -20°C to 60°C, < 80%RH
Long Term : The battery should be stored in an environment
with low humidity, free from corrosive gas at a recommended
temperature range between 5 and 25°C. Extended exposure
to temperatures above 45°C could degrade battery
performance and life.
Up to 50,000 feet (15,000 metres)
P
S
T
ACKING FOR
TORAGE OR
RANSPORTATION
41
Advertisement
Table of Contents
