Table of Contents
Advertisement
3
Selection of Installation Place
Upon customer's approval, install the air conditioning apparatus in a place which satisfies the following
conditions:
Place where it can be installed horizontally.
Place which can reserve a sufficient service space for safe maintenance or checks.
Place where there is no problem even if the drained water overflows.
Avoid the following places:
Salty places (seaside area) or places with much gas sulphide (hot spring area) (If selecting such a place, special maintenance is
required.)
Places where oil (including machine oil), steam, oil smoke or corrosive gas is generated.
Places where iron or other metal dust is present. If iron or other metal dust adheres to or collects on the interior of the air conditioner,
it may spontaneously combust and start a fire.
Places where an organic solvent is used.
Chemical plants with a cooling system using liquid carbon dioxide.
Places where a device generating high frequency (inverter, non-utility generator, medical apparatus, or communication equipment) is
set. (Malfunction or abnormal control of the air conditioner, or interference to devices listed above may occur.)
Places unable to bear the weight of the apparatus.
Places with poor ventilation.
Places where ambient temperature falls below -15°C for more than 72 hours running.
4
Refrigerant Piping
-GAS Label
The air conditioning product contains fluorinated greenhouse gases covered by the Kyoto Protocol
Chemical Name of Gas
Global Warming Potential (GWP) of Gas
CAUTION
1. Stick the enclosed refrigerant label adjacent to the charging and/or recovering location.
2. Clearly write the charged refrigerant quantity on the refrigerant label using indelible ink. Then, place the included transparent
protective sheet over the label to prevent the writing from rubbing off.
3. Prevent emission of the contained fluorinated greenhouse gas. Ensure that the fluorinated greenhouse gas is never vented to the
atmosphere during installation, service or disposal. When any leakage of the contained fluorinated greenhouse gas is detected, the
leak shall be stopped and repaired as soon as possible.
4. Only qualified service personnel are allowed to access and service this product.
5. Any handling of the fluorinated greenhouse gas in this product, such as when moving the product or recharging the gas, shall comply
under (EC) Regulation No. 842/2006 on certain fluorinated greenhouse gases and any relevant local legislation.
6. Periodical inspections for refrigerant leaks may be required depending on European or local legislation.
7. Contact dealers, installers, etc., for any questions.
R410A
1975
[9]
Advertisement
Table of Contents
