Setting Up And Connecting - Silvercrest 339256 1910 Operating Instructions Manual

WARNING! RISK OF INJURY!
Route the power cable in such a way that no one can tread on or
►
trip over it.
Never touch the cooking plates during use as these become very
►
hot.
Do not use extension cables. The plug must be quickly accessible
►
in an emergency.
Do not use an external timing switch or a separate remote control
►
system to operate the appliance.
Caution! Hot surfaces.
CAUTION - RISK OF FIRE!
Never leave the appliance unattended while it is being used.
►
When the appliance is in use ensure that there are no easily inflamma-
►
ble materials close to it (e.g. dishcloths, oven cloths etc.).
If you do not intend to use the appliance for an extended period,
►
you must disconnect it from the power source. The appliance is
only completely without current when the power plug has been
pulled out of the socket.

Setting up and connecting

1) Place the appliance on a stable, level and heat-resistant surface.
2) Insert the plug into a mains power socket.
3) Switch the appliance on by switching the On/Off switch
4) Set the two thermostats
about 3 minutes without any pan on them.
This can cause slight smoke development since the protective coating which has
been applied will burn in. Ensure there is sufficient ventilation. For example, open
a window.
5) Switch off the hobs
│ GB │ MT
■ 42
/ to MAX and allow the hobs
/ after 3 minutes.
to the position "I".
/ to heat up for
SDK 2500 B1