Motorwell Bridge (Optional) - Quicksilver Activ 755 Open Owner's Manual

Quicksilver 755OP — System & Component Overview and Operation
potentially enter the bilge. Quicksilver® suggests that prior to installing or removing the ski pylon,
spray water on the ski pole to help slide it through the deck plate.
When the ski pole is not in use, Quicksilver® recommends that you secure the pole in the cabin.
Ski Pole
The deck plate is a downflooding point. When the ski pole is
not in use, verify that the deck plate is properly installed.
Failure to do so may result in injury or death.
The ski pylon is only used for water skiing or wakeboarding. If you are tubing or engaging in other
recreational towing, Quicksilver® recommends that you attach the tow rope to the stern eyes at the
transom of your boat.

21. Motorwell Bridge (optional)

An optional motorwell bridge is available which allows for easy passage between the port and
starboard swim platforms. To use, remove the latch and rotate the bridge into position. When the
boat is underway or the motorwell bridge is not in use, Quicksilver® recommends that the bridge is
stored in the vertical position.
Only tow water skis or wakeboards. Do not tow parasails,
kits, or other boats. Do not tow more than two persons at
one time. Use caution with skier in tow as rope may snap
back into cockpit when released. Failure to follow these
guidelines may result in injury or death.
Remove the ski pylon from the base before using the
motorwell bridge. Failure to do this will damage both the ski
pylon and motorwell bridge.
Remove the ski pylon from the base before raising engine to
trailer mode to avoid any damage to the engine cowl.
37
Ski pylon
Deck plate
Stern eyes
Ski pole base