Sharp NoteVision XG-NV6XA Operation Manual page 14

2. Connecting the Projector
Connecting the Projector to Video Equipment
You can connect your projector to a VCR, laser disc player, DVD player, DTV* decoder and other audiovisual
equipment.
CAUTION
• Always turn off the projector while connecting to video equipment, in order to protect both the projector and the equipment
being connected.
Connecting a VCR, laser disc player and other audiovisual equipment using the standard video Input
Connecting a DVD player, DTV decoder and other component video equipment using the 5 BNC Input
Three BNC-RCA adaptors
QPLGJ0107GEZZ
*DTV is the umbrella term used to describe the new digital television system in the united states.
13
1 Connect the yellow RCA connectors to the corresponding yellow VIDEO INPUT
terminal on the projector and the Video output terminal on the video source.
2 To use the built-in audio system, connect the red and white RCA connectors
to the corresponding red and white AUDIO INPUT terminals on the projector
and the Audio output terminals on the video source.
The S-VIDEO INPUT terminal uses a video signal system in which the picture is
separated into a colour and a luminance signal to realise a higher-quality image.
• For higher quality video, you may use the S-VIDEO INPUT terminal on the projector. S-video
cable is sold separately.
• If your video equipment does not have an S-video output terminal, use the Composite
video output terminal.
2
Audio cable (sold separately)
1
Video cable (sold separately)
S-video cable (sold separately)
1 To use the 5 BNC connector, slide the 15 pin/BNC switch on the rear terminals
to the BNC position. Connect each BNC connector to the corresponding BNC
INPUT 1 terminals on the projector.
• BNC-RCA adaptors are included for use with RCA type cables and sources.
2 Connect the other end of the cable to the corresponding terminals of a DVD
player or DTV decoder.
3 To use the built-in audio system, connect one end of the supplied computer
audio cable to AUDIO INPUT 1 or 2 terminal on the projector.
Connect the other end to the Audio output terminal on the computer.
• A 3.5 mm minijack to RCA audio cable adaptor may be necessary.
When connecting this projector to a DVD player or a DTV decoder, select
"Component" for "Signal Type" on the GUI menu. (See page 40.)
Audio cable (sold separately)
To audio output terminals
To video output terminal
To S-video output terminal
To audio output terminals
3 To analog component
output terminals
Component cable (sold separately)
Continued
VCR
or
Laser disc player
DTV decoder
or
DVD player