Sharp Notevision XG-NV6XU Quick Reference

Quick Reference for XG - NV6X
A. Connecting the Power Cord
Plug the supplied power cord into the AC socket on the back of the
projector.
B. Connecting a Computer
1 Slide the 15 pin/BNC switch on the rear terminals to the 15 pin
position.
2 Plug one end of the supplied computer cable into the INPUT 1
or 2 port on the projector and the other end into the monitor
output port on the computer, and secure the plugs by tightening
the thumb screws.
3 Plug one end of the supplied computer audio cable into AUDIO
INPUT 1 or 2 terminal on the projector and the other end into
the audio output port on the computer.
4 Press POWER ON.
5 Turn on the computer.
6 Press AUTO SYNC to adjust the image.
XG-NV6XU/QR (E) 1
POWER ON
button
AUTO SYNC
button
C. Connecting the Remote Mouse Receiver
IBM or IBM compatible PC
1 Connect one end of the supplied mouse control cable to the
corresponding terminal on the PC.
2 Connect the other end to the remote mouse receiver.
Macintosh
1 Connect the mouse control serial cable to the remote mouse
receiver.
2 Connect the mouse control cable for Mac to the Mac ADB
port on the Mac.
3 Connect the other end of the mouse control cable for Mac to
the mouse control serial cable.
• Make sure that your computer is turned off while making any mouse control cable
connections.
• When using the wireless mouse with an IBM or IBM compatible PC, you can use
either a PS/2 or serial cable connection. (See diagram below.)
• Use the supplied mouse control cable for Mac when using the remote mouse receiver
with a Macintosh computer.
Remote mouse receiver
Mouse control cable for IBM PS/2
Mouse control
cable for Mac
D. Connecting a DVD Player, DTV Decoder
and Other Component Video Equipment
1 Slide the 15 pin/BNC switch on the rear terminals to the BNC
position.
2 Plug the supplied BNC-RCA adaptors to INPUT 1 terminals
(R(P ), G/G sync(Y), B(P )).
R B
3 Connect a component cable and an audio cable to the
corresponding terminals on the projector and video source.
Audio cable
(sold separately)
To analog component
output terminals
Component cable
(sold separately)
Three BNC-RCA adaptors
While this projector can input COMPUTER/RGB and
COMPONENT signals through the 15-pin D-sub terminals (INPUT
1 and 2 ports) and BNC terminals (INPUT 1 terminals), the
projector cannot distinguish between the two types of signals.
When inputting these signals through the aforementioned
terminals, you must indicate the input signal type. (See "Selecting
the Signal Type" in the operation manual.)
99.11.8, 2:05 PM
LCD Projector
Use this terminal to connect the
supplied mouse control cable
to the remote mouse receiver.
Mouse control
serial cable
To audio output terminal
DTV decoder
or
DVD player