Yamaha Lexi ABS GDS125-A Owner's Manual page 66

Periodic maintenance and adjustment
2
1. Panel B
2. Screw
To install the panel
1. Place the panel in the original po-
sition, and then install the screws.
2. Close the seat.
Panel C
To remove the panel
9
1. Open the seat.
2. Remove the grab bar by removing
the bolts.
1
1
1. Grab bar
2. Bolt
3. Remove the screws from panel C,
and pull the panel up, then slide
backward as shown.
2
1. Panel C
2. Screw
3. Pull
4. Slide backwards.
To install the panel
2
TIP
Make sure that the grab bar is properly
tightened before riding.
1
4
3
9-9
1. Place the panel in the original po-
sition, and then install the screws.
2. Install the grab bar by installing the
bolts.
Tightening torque:
Grab bar:
9 N·m (0.9 kgf·m, 6.6 lb·ft)
3. Close the seat.