Handlebar Switches - Yamaha Lexi ABS GDS125-A Owner's Manual

Handlebar switches

Left
1
2
3
1. Dimmer switch " / "
2. Turn signal switch " / "
3. Horn switch " "
Right
1
2
3
1. Stop and Start System switch "
/
2. Hazard switch " "
3. Start switch " "
EAU1234M
Dimmer switch "
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Start switch "
With the sidestand up, push this switch
while applying the front or rear brake to
crank the engine with the starter. See
page 8-1 for starting instructions prior
to starting the engine.
A
A / "
Instrument and control functions
EAU12402
/ "
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
EAU12501
"
EAU12722
"
6-8
Hazard switch " "
With the main switch in the "ON" posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Stop and Start System
switch " / " A
A
To turn on the Stop and Start System,
set the switch to " ". To turn off the
A
Stop and Start System, set this switch
to " ". A
EAU79500
ECA10062
6
EAU76391