Configuring Wireless Device Settings - VESTEL STAR WARS SAGA 22FA7100 Operating Instructions Manual

is installed to your PC (for Audio Video
Sharing function).
2. Then connect the wireless adaptor to one
of the USB inputs of the TV.
3. To configure your wireless settings please
refer to the Network/Internet Settings
section in the System>Settings Menu.
Broadband ISP connection
A Wireless-N router (IEEE 802.11a/b/g/n)
with simultaneous 2.4 and 5 GHz bands is
designed to increase bandwidth. These are
optimized for smoother and faster HD video
streaming, file transfers and wireless gaming.
• Use a LAN connection for quicker file sharing
between other devices like computers.
• The frequency and channel differ depending
on the area.
• The transmission speed differs depending
on the distance and number of obstructions
between the transmission products, the
configuration of these products, the radio
wave conditions, the line traffic and the
products that you use. The transmission
may also be cut off or may get disconnected
depending on the radio wave conditions,
DECT phones or any other WiFi 11b
appliances. The standard values of the
transmission speed are the theoretical
maximum values for the wireless standards.
They are not the actual speeds of data
transmission.
Wireless LAN
adaptor
USB inputs on the rear left
side of the TV
English - 86 -
• The location where the transmission is most
effective differs depending on the usage
environment.
• The Wireless LAN adaptor should be
connected directly to the TV's USB port.
USB hubs are not supported. You can plug
your wifi dongle into a extension dock in
cases where network quality is poor and the
wifi dongle needs to be placed to a location
with better signal quality.
• The Wireless LAN adaptor supports
802.11 a,b,g & n type modems. It is highly
recommended that you should use the IEEE
802.11n communication protocol in order to
avoid any possible problems while watching
videos.
• Use the other USB input, if you experience
problems with audio/video performance.
• You must change your modem' s SSID when
there are any other modems around with the
same SSID. You can encounter connection
problems otherwise. Use a wired connection
if you experience problems with a wireless
connection.

Configuring Wireless Device Settings

To enable Wi-Fi features, plug in the Wi-Fi
dongle to one of the USB ports. Open the
Network/Internet Settings menu and select
Network Type as Wireless Device to start
connection process.
The TV will scan the wireless networks
automatically. A list of available networks
will be displayed. Please select your desired
network from the list.
NOTE: If the modem supports N mode, you should set N
mode settings.
If the selected network is protected with a
password, please enter the correct key by using
the virtual keyboard. You can use this keyboard
via the directional buttons and the OK button
on the remote control.
Wait until the IP address is shown on the screen.