Table of Contents
Advertisement
3
Operation
3.1
Preparation
Slide lever (1) to the left to fold down the cutter unit (2).
1
2
Insert labels for tear-off mode Instructions of the printer.
Place the media strip between the printhead and the drive roller, so that
the front edge of the strip reaches through the cutter.
Insert ribbon Instructions of the printer.
Fold up and lock the cutter unit (2).
Activate the cut mode in the software.
In direct programming use the "C" command.
Programming Manual of the printer.
Configure the cut parameters 4. Printer Configuration
i
Note!
The cut parameters are only accessible with cutter installed.
11
Advertisement
Table of Contents
