Standard Operation; Cutting On Demand - CAB CSQ 401 Assembly Instructions Manual

12 3 Operation
3.2

Standard Operation

 Switch on the printer.
The cutter performs a synchronization action.
i
Note!
To operate the cutter with continuous material in the printer menu
Setup - > Labels - > Label sensor the setting Continuous media has to be
selected. Otherwise no synchronization cut is carried out.
 Press
cut off.
That synchronization is not necessary when the printhead was not opened
between print jobs, even if the printer was powered off between print jobs.
 Send a print job.
All labels in the job will be printed without stopping and be cut as chosen in
the software : after each label, after a specific quantity of labels, or at the
end of a print job.
i
Note!
Between the print jobs a direct cut can be released by pressing
i
Note!
In case the material do adhere in follow of electrostatic charge it's
possible to mount an antistatic brush (Part No. 5977339) on the
printer.
3.3

Cutting on Demand

In the "Cut on Demand" mode the print job will be split into steps, which can
be released separately.
 Choose Printing > Print on demand = On.
 4. Printer Configuration.
 Send a print job.
 Press
The first label will be printed and cut.
 Press
i
Note!
The
START signal when the I/O interface is installed on the printer.
 Configuration Manual of the printer.
. For synchronization the media will be moved forward and
on the control panel.
.
again to print and cut the next label.
function can be released alternatively by an external
12