Print Style Setting; Fax Receive Settings; Number Of Calls In Auto Reception - Sharp MX-M283 Operation Manual

Fax Receive Settings

Settings for fax reception can be configured.

Number of Calls in Auto Reception

This setting is used to select the number of rings on
which the machine automatically receives a call and
begins fax reception in auto reception mode. Any
number from 0 to 15 can be selected.
If you select "0" for the number of rings, the machine
will immediately answer and begin fax reception
without ringing in auto reception mode.
Duplex Reception Setting
This is used to have received faxes printed on both sides
of the paper.
When this setting is enabled and a fax consisting of 2 or
more pages is received (the pages must be the same
size), the pages are printed on both sides of the paper.
Auto Receive Reduce Setting
When a fax is received that includes the sender's name
and number, the received image is slightly larger than
the standard size. This setting is used to automatically
reduce the image to fit the standard size.
• If Auto Receive Reduce is disabled, the edges of
the image outside the standard size will be cut off.
However, the image will be clearer because it will
be printed at the same size as the original.
• Standard sizes are sizes such as 8-1/2" x 11" and
8-1/2" x 5-1/2" (A4 and B5).

Print Style Setting

This setting determines the paper selection condition
when printing received faxes. Select one of the three
conditions below.
Print Actual Size Cut off Disabled
The received fax image is printed at full size without
dividing it onto multiple sheets of paper. If the same size
of paper or larger paper is not loaded, the fax will be
received in memory and will not be printed until a
suitable size of paper is loaded.
However, if the received fax is longer than 11" x 17" (A3)
size, it will be automatically divided onto multiple sheets
of paper.
Print Actual Size Cut off Enabled
Each received image is printed at full size. If necessary,
the image is divided onto multiple sheets of paper.
Auto Size Select
Each received image is printed at full size when
possible. When not possible, the image is automatically
reduced before printing.
Set the Telephone Number for Data
Forwarding
When a problem prevents the machine from printing a
received fax, the received fax can be forwarded to
another fax machine. This setting is used to program the
fax number of the destination fax machine. Only one
forwarding fax number can be programmed (maximum
of 64 digits).
To insert a pause between digits of the number, touch
the [-] key.
If you wish to specify an F-code confidential memory box
in the destination machine, touch the [/] key after
entering the fax number and enter the F-code
(sub-address and passcode).
7-108
SYSTEM SETTINGS
Contents