Making Copies Using The Bypass Tray - Sharp MX-M283 Operation Manual

MAKING COPIES USING THE BYPASS TRAY

In addition to plain paper, the bypass tray allows you to make copies on transparency film, envelopes, tab paper, and
other special media.
For detailed information on paper that can be loaded in the bypass tray, see
(page 1-27) in "1. BEFORE USING THE MACHINE". For precautions when loading paper in the bypass tray, see
"LOADING PAPER IN THE BYPASS
1
2
Exposure
Auto
3
Copy Ratio Original
100%
TRAY" (page 1-34) in "1. BEFORE USING THE MACHINE".
Special Modes
2-Sided Copy
Plain
8½x11
Output
1. 8½x11
8½x11R
2.
File
8½x14
3.
11x17
4.
Quick File
Paper Select
Auto Auto
8½x11
8½x11 Preview
Plain
"IMPORTANT POINTS ABOUT
Place the original.
Place the original face up in the document feeder tray, or face
down on the document glass.
When placing the originals on the document glass...
After placing the original, be sure to close the automatic
document feeder. If left open, parts outside of the original will
be copied black, causing excessive use of toner.
Place paper in the bypass tray.
Insert the paper with print side face down.
However, if the paper type is "Letter Head" or "Pre-Printed",
load the paper with the print side face up*.
* If "Disabling of Duplex" is enabled in the system settings
(administrator), load the paper in the normal way (face up in
trays 1 to 5; face down in the bypass tray).
When loading paper larger than 8-1/2" x 11"R or A4R, be sure
to pull out the bypass tray extension. Pull the bypass tray
extension all the way out. If the bypass tray extension is not
pulled all the way out, the size of the loaded paper will not be
correctly displayed.
Touch the [Paper Select] key.
2-38
COPIER
PAPER"
Contents