Setting The Impact Force; Use; Switching On And Off; Stapling/Nailing - Parkside PET 25 C3 Translation Of The Original Instructions

Setting the impact force

NOTE
► Select the lowest impact force sufficient for
stapling . Take into account the length of the
staples or nails you are using as well as hard-
ness of the material you are working with .
Impact force control
Increasing the impact force
♦ Turn the impact force control
Reducing the impact force
♦ Turn the impact force control

Use

Switching on and off

♦ Set the ON/OFF switch
switch the appliance on .
♦ Set the ON/OFF switch
switch the appliance off .
■ 36 │ GB │ MT
anticlockwise .
clockwise .
to the position "I" to
to the position "0" to

Stapling/nailing

♦ Switch the appliance on by moving the ON/
OFF switch to the position "I" .
♦ Press the face plate
the location on the material that you want to
staple/nail .
♦ Press the trigger
NOTE
► The integrated safety switch on the face plate
prevents accidental triggering .

Working with the rip fence

If you want to tack with nails or staples at a
constant distance to an edge, proceed as follows:
♦ Pull out the rip fence
arrow .
♦ Move the rip fence
is at the required distance from the edge of the
object that you want to work on .
♦ Place the rip fence
object that you want to work on .
Proceed as described in the section Stapling/
♦
nailing .
of the appliance onto
.
in the direction of the
along the scale
onto the edge of the
PET 25 C3
until it