Tape Playback; Listening To A Cassette Tape (Tape 1 Or Tape 2) - Sharp CD-DK890N Operation Manual

Listening to a cassette tape (TAPE 1 or TAPE 2)

CD-DK890N
Before playback:
For playback, use normal or low-noise tapes for
the best sound. (Metal or CrO tapes are not
recommended.)
Do not use C-120 tapes or poor-quality tapes, as
they may cause malfunctions.
Before loading a tape into the cassette compartment,
tighten the slack with a pen or a pencil.
POWER
ON/ STAND-BY
32
5
4
3
2
1
TIMER
CD
5
4
3
2
1
PLAYBACK (PLAY & STOP) RECORD/PLAYBACK
AUDIO
PHONES IN

Tape playback

1
Press the ON/STAND-BY button to turn the power on.
2
Open the cassette
compartment by
pushing the area marked
" ".
3
Load a cassette into the
TAPE 1 compartment or
TAPE 2 compartment
with the side to be played
facing toward you.
4
Press the TAPE (1 2) button to select the cassette you
want to listen to.
5
Press the / (TAPE
button to start playback.
Auto power on function:
When you press any of the following buttons, the unit turns on.
TAPE (1 2) button (main unit and remote control): The unit turns
on and the "TAPE" function is activated.
TAPE button (remote control): The unit turns on and the "TAPE"
function is activated.
/ button (main unit): The unit turns on and playback of the last
function starts (CD, TAPE, TUNER, AUDIO IN, iPod).
Auto power off function:
In the stop mode of tape operation, the main unit enters the stand-by
mode after 15 minutes of inactivity.
)
Tape play indicator