Message Type Payload
0xfb
Link quality
0xfe
--
0xff
1-byte status
Reset Message (0x00)
Every time a sensor powers up it sends a reset message to the cloud.
The reset message payload is defined in the following table.
Bytes
0
1
2-3
4-5
Firmware Version
The 16-bit firmware version is constructed from reset payload Bytes 2-3, where Byte 2 is the most significant byte.
Beginning with version 2.0, the format is as shown in the following table.
The original format is compatible by redefining the reserved most significant bit (Bit 15).
Byte
Description
15
Format (bit == 0)
14:8
Major number (7 bits)
7:0
Minor number (8 bits)
15
Format (bit == 1)
14:10 Major number (5 bits)
9:5
Minor number (5 bits)
4:0
Build number (5 bits)
16-Bit Firmware Version Examples
0x0103 is decoded as Firmware Version 1.3
0x8823 is decoded as Firmware Version 2.1.3
®
Radio Bridge LoRaWAN
Description
Sensor type code, a product identifier sent as part of the reset message. (The
following code is specific to your device).
Air Temperature and Humidity 0x0e
Hardware version.
Firmware version.
Reset code. Used for factory diagnostics.
Wireless Sensor Air Temperature Humidity Sensor User Guide
Description
Sent after each downlink configuration (refer to
Message) or to periodically ping the network server (refer to
Link Quality Check
Period).
Reserved.
Downlink message ACK. Refer to
COMMON MESSAGES
Link Quality
Downlink ACK
for more detail.
13
Need help?
Do you have a question about the RBS3010NA0EBN0 and is the answer not in the manual?