Emotiva BASXMR1-L User Manual page 39

BasX MR1 9.2 Channel Cinema Receiver
L
SETUP - ABOUT
This menu gives you access to a variety of information about the various firmware modules
currently installed on your MR1L and some of the devices connected to your MR1L.
Software Update - This option is used to update the firmware on your MR1L.
Note: Firmware is updated by placing the firmware update file on a USB stick, formatted with a
standard FAT32 format, and inserting the stick into the rear panel Update USB port.
Firmware update may be initiated by either:
1. Inserting the USB stick containing the firmware update file into the rear panel Update port
while the MR1L is powered Off, then turning the MR1L On. At this point the MR1L will detect the
firmware file automatically and install it.
2. Inserting the USB stick containing the firmware file while the MR1L is powered On and then
selecting Software Update from this menu.
NOTE: The firmware update will take several minutes and will display a progress indicator.
DO NOT DISCONNECT POWER TO THE MR1 OR REMOVE THE STICK DURING THE UPDATE.
You will see a message when the update is completed, and your MR1L may return to either On
or Standby mode - depending on how the update was initiated. You will NOT be required to
update your MR1L to factory defaults after most updates.
DO NOT remove the USB stick until the firmware update is complete. Once the update is
complete the MR1L will shut down, reboot, and display the new firmware version. At that point
you can remove the USB stick.
MCU Version, DSP Version, OSD Version - These items display useful information about the
firmware modules installed on the MR1L.
Bluetooth Name - Displays the Bluetooth Name that will be associated with the MR1L when
other devices are paired with it. You MAY change the name that the MR1L displays to other
Bluetooth enabled devices.
Bluetooth MAC - This item displays the network hardware address of the Bluetooth network
receiver inside the MR1L.
TV Connect 1, TV Connect 2 - This item displays some useful information about the HDMI
devices currently connected to the HDMI outputs of the MR1L.
Page 33