Emotiva BASXMR1-L User Manual page 21

BasX MR1
4. Bluetooth Antenna
This is the antenna for the internal Bluetooth receiver in the MR1L, which supports the latest
Bluetooth and AptX-HD audio standards.
5. Microphone Input (For EmoQ Automatic Room Correction)
Connect the provided calibrated microphone to this input when you are preparing to run the
EmoQ Automatic Room Correction feature in the MR1L. You should always use the calibrated
microphone provided with the MR1L. If you use a different microphone it may produce unusual
results, or even damage your microphone or the MR1L.
Note: You should connect the microphone before starting EmoQ. You do not need to leave the
microphone connected except when you're planning to run EmoQ.
6. IR Remote Input
Use the IR Remote Input to connect the signal from an external IR remote control repeater or hub.
Note: This input requires an active signal from an IR repeater or hub.
7. Trigger Output
A 12 VDC signal is sent from the Trigger Output of the MR1L to turn on other devices when the
MR1L is turned on. This signal can be used to turn on other trigger-enabled audio equipment -
such as a power amplifier.
Note: We recommend using the Trigger Output on the MR1L to turn on your amplifiers
automatically when you power on the MR1L. This will prevent any noises from being sent to
your speakers as the circuitry in the MR1L starts up. (If the MR1L is left in Standby Mode, rather
than fully powered Off, the muting circuitry in the MR1L will ensure that it starts up silently.)
Note: The Trigger Output can be reconfigured to only become active when specific Inputs are
selected. The setting required to enable this feature is located in the Setup | Options Menu.
Once this feature has been selected you may then configure how the Trigger Output will
respond to each Input in the setup menu for each of the Inputs.
8. USB Update Input
This input is used to update the firmware on the MR1L from a firmware update file on a USB stick.
Note: This USB port CANNOT be used to play audio or video files from a USB stick.
9.2 Channel Cinema Receiver
L
Page 15