Basx Mr1L Rear Panel - Emotiva BASXMR1-L User Manual

BasX MR1

BasX MR1L Rear Panel

1
SW1 BAL SW2 BAL
ANALOG
INPUTS
SW1 SW2 RRH
13.2 ANALOG
OUTPUTS
RIGHT REAR HEIGHT RIGHT SURROUND RIGHT FRONT HEIGHT
RIGHT BACK SURROUND RIGHT SURROUND RIGHT HEIGHT
11
1. Subwoofer Outputs
The MR1L has two Balanced Subwoofer Outputs and two Unbalanced Subwoofer Outputs.
All four subwoofer outputs deliver the same audio information.
However there are independent Level Trim and Distance settings for SW1 and SW2.
Note: For either SW1 or SW2 both the Balanced and Unbalanced Subwoofer Outputs are active
at the same time.
Note: If you configure the MR1L to have Two Subwoofers then both the SW1 and SW2 Outputs
will be active. If you configure the MR1L to have One Subwoofer then ONLY the SW1 Outputs
will be active.
2. Stereo Analog Inputs
Use these inputs to connect your analog stereo sources. They might be used to connect the
output of a phono preamp or tuner, or you could connect the analog output of a phone or music
player to one of these inputs with the appropriate adapter cable.
3. Digital Audio Inputs
Use these inputs to connect a digital audio source. The MR1L includes two electrical S/PDIF (Coax)
inputs and two optical S/PDIF (Toslink) inputs. These inputs accept stereo audio at sample rates
up to 24/192k and low bandwidth digital surround sound formats like Dolby Digital and DTS
Digital Surround.
9.2 Channel Cinema Receiver
L
2 3
CO1
L
R
OPT1
AN1 AN2 AN3 AN4 DIGITAL INPUTS
RMH RFH RBS RS RF
(RW) (RMH)
5.1.4 CHANNEL CONFIGURATION
RIGHT FRONT CENTER LEFT FRONT
7.1.2 CHANNEL CONFIGURATION
RIGHT FRONT CENTER
12
4 5 6
BT ANTENNA EMO-Q MIC
CO2
2 1 (eARC) 1
OPT2
HDMI OUTPUTS
C LF LS LBS LFH
(LMH)
LEFT FRONT HEIGHT LEFT SURROUND LEFT REAR HEIGHT
LEFT FRONT LEFT HEIGHT LEFT SURROUND LEFT BACK SURROUND
13
Page 14
7 8 9 10
IR TRIG
IN OUT
UPDATE USB RS232
2 3 4 5
HDMI INPUTS
LMH LRH
115V POWER 230V
(LW)
AC INPUT
14 15
6
16