Replacing An Optical Drive - Lenovo 3000 H100 Hardware Maintenance Manual

Replacing an optical drive

7. Connect the power and data cables to the hard disk drive. Refer to
"Identifying parts on the system board".
8. Refer to the "Completing the installation".
Attention
Do not remove the computer cover or attempt any repair before
reading the "Important safety information" in the Safety and Warranty
Guide that was included with your computer or in the Hardware
Maintenance Manual (HMM) for the computer. To obtain copies of the
Safety and Warranty Guide or HMM, go to the Support Web site at
http://consumersupport.lenovo.com
To replace an optical drive
1. Remove the computer cover. Refer to "Removing the computer cover".
2. Remove the front bezel. Refer to "Removing and replacing the front
bezel".
3. Disconnect the data and power cables from the rear of the optical drive.
4. Remove the two screws that secure the optical drive from drive bay.
5. Push the optical drive straight out of the front of the chassis.
Chapter 7. Replacing hardware
45