Maytronics Dolphin S 300i User Instructions page 4

Keep the Robot Pool Cleaner out of the reach of children or persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
WARNING given supervision or instruction.
The unit must be connected only to a supply circuit that is protected by a ground-fault circuit
interrupter (GFCI). This GFCI should be tested on a routine basis. To test the GFCI, push the test
button. The GFCI should interrupt power. Push the reset button. Power should be restored. If
the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the
power unit without the test button being pushed, a ground current may be flowing, indicating
WARNING
the possibility of an electric shock. Do not use the power unit. Disconnect the power unit and
contact the manufacturer for assistance.
Only an original power cable must be used, at all times. Replaced by a Robot Pool Cleaner
certified technician, in case of need to avoid hazard.
WARNING
To reduce the risk of electric shock replace damaged cord immedietely.
Do not use extension cord to connect unit to electric supply; provide a properly located outlet.
WARNING
Use the originally supplied power supply only
WARNING
Please ensure that the following PRECAUTIONS are implemented:
Operator should keep hands away from driving belt mechanism.
CAUTION
Position the Caddy and power supply at least 3.5m/12ft from pool's edge – during operation.
CAUTION
For continued protection against possible electric shock, the power supply unit should be placed
at least 11cm/4in above ground.
CAUTION
When lifting the Robot Pool Cleaner, take care to prevent back injury.
CAUTION
Do not bury cord – locate cord to minimize abuse from lawn mowers, hedge trimmers and other
equipment.
CAUTION
When not in use, store the Pool Cleaner on its Caddy in a shaded area. Use the Pool Cleaner in the following
water conditions only.
Chlorine
pH
Temperature
NaCl
S 300i User Instructions
Max 4 PPM
7.0-7.8 PPM
6-35°C / 43-95°F (below 15°C / 59°F climbing performance may be affected)
Maximum = 5000 PPM
3