Wilo Control SC2.0-Booster Installation And Operating Instructions Manual page 43

7.2.3.1 Menu system -> Pumps
Fig. 87: Menu system -> Pumps menu item
Fig. 88: System→Pumps→Installation menu
item
Fig. 89: System→Pumps→Statistics 1/2
menu item
Fig. 90: System→Pumps→Statistics 2/2
menu item
Fig. 91: System→Pumps→CAN fallback
menu item
Installation and operating instructions • Wilo-Control SC2.0-Booster • Ed.01/2023-09
Settings and data for the pumps used.
Number of pumps installed in the system.
Maximum number of pumps running simultaneously.
The remaining pumps serve as standby pumps.
Running time data for the control device and the pumps.
Current speeds and calculated power for each pump.
The fallback setting in case of a communication problem between the control device and the
pump.
The setting determines the behaviour of the pump when the control device no longer per-
forms.
When "Stop" is selected, the pump is stopped.
When "Continue" is selected, the pump continues to operate in the n-c control mode at the
speed indicated below.
The speed can then be changed on the pump's HMI. When communication with the control
device is re-established, the control device takes over control of the pump.
en
43