4: Can Interface - Copley Controls Xenus XSL-230-40 User Manual

Quick Setup with CME 2

5.9.4: CAN Interface

For more information, see
Verify that the following connections are wired according to the instructions in
5.9.4.1
CAN Bus (J6) (p.
1. J6 "CAN" CANopen cable
2. J6 "CAN" Termination plug
Click CAN Configuration (
5.9.4.2
CAN is not the Position Loop Input, choose Amplifier>CAN Configuration instead.)
Choose a Bit Rate.
5.9.4.3
Check the appropriate buttons to choose any combination of address sources (Switch,
5.9.4.4
Inputs, and Programmed Value). The address is the sum of the values from these
sources.
For each source selected, perform the additional steps described below.
5.9.4.5
Source
Use Switch
Use Inputs
Use
Programmed
Value
Click OK to close the screen and save the changes to flash,
5.9.4.6
OR click Cancel to close the screen without saving the changes.
NOTE: CAN address and bit rate are changed only after +24 Vdc power-up or reset.
104
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
CAN Addressing (p. 31).
67):
) to open the CAN Configuration screen. (If
Steps
Verify the S1 switch setting.
Enter the Number of inputs.
Choose the input that will represent each
CAN address bit.
Enter the Programmed value.
Xenus XSL User Guide
Comments
Assigns values for Bit 0 – Bit 3 of CAN
address.
Copley Controls Corp.