Daikin BRC7M530W Operation & Installation Manual page 26

(4) Installation of the decoration panel
Install the decoration panel as descr bed in
the Installation Manual supplied with the
decoration panel.
NOTE
• Make sure that the wire harness (longer one)
from the transmission is not caught between
the indoor unit and the decoration panel, and
between the ceiling and the decoration panel.
The installation process of the receiver
depends on used decoration panel.
Installation of the receiver in case of
BRC7M530W/531W
1. Remove the suction grille as described in
manual supplied with the decoration panel.
The corner where the wireless kit belongs
is set by the two square marks.
Then remove the plastic corner cover.
23
2. Break off the plastic cover from back side
of the panel.
3. Pass the cable through the hole and insert
the cover into its position and screw it.
Clamp (4) the cable to the
hook next to the positioning
tie wrap.
Clamp (4) the cable
to others cables.
1. Remove the screw
2. Insert the plastic holder (7)
(supplied with receiver) the
cable should go through the
clamp
3. Put the screw back
Receiver
assembly (1)
Tie wrap for
positioning.
Stick the sealing
material (5) (supplied
with receiver) around
the cable in the place
where the cable
enter the unit.