Checking Pattern Combination Length - Janome Memory Craft 9450QCP Instruction Book

q w
e
r

Checking Pattern Combination Length

You can check the total length of the pattern combination
by pressing on the pattern combination length key
indicated in the manual setting window.
Press the setting bar to open the manual setting window.
q Setting bar
w Pattern combination length key
The readout of the total length is a theoretical value
and the actual length may vary depending on sewing
conditions.
For example, select the pattern P5 three times, and sew
a pattern combination.
If the actual length differs considerably from the readout,
measure the actual length and enter the nearest value by
pressing the "+" or "–" key.
In this case, the theoretical value is 51 mm. However, if
the actual length e is 40 mm, enter 40 mm by pressing "–"
key. Press the OK to register it.
e Actual length
The readout is adjusted automatically when calculating
the length of other pattern combinations.
The message "Please enter the actual length of the
pattern combination" disappears to indicate that the
displayed value is adjusted already.
For example select patterns P10, P15 and P5.
The theoretical value is 53 mm. However, the read out is
calculated according to the measured actual length. In
this case, the adjusted value is 42 mm.
Press the default key to clear the entered actual length.
r Default key
74