Checking Pattern Combination Length - Janome Memory Craft 15000 Instruction Manual

q
w

Checking Pattern Combination Length

You can check the total length of the pattern combination
by pressing on the stitch image indicated in the left
window.
The readout of the total length is a theoretical value
and the actual length may vary depending on sewing
conditions.
For example, select the pattern P6 three times, and sew
a pattern combination.
If the actual length differs considerably from the readout,
measure the actual length and enter the nearest value by
pressing the "+" or "–" key.
In this case, the theoretical value is 51 mm. However, if
the actual length q is 45 mm, enter 45 mm by pressing "–"
key. Press the OK to register it.
q Actual length
The readout is adjusted automatically when calculating
the length of other pattern combinations.
The message "Please enter the actual length of the
pattern combination" disappears to indicate that the
displayed value is adjusted already.
For example select patterns P19, P27 and P6.
The theoretical value is 53 mm. However, the read out is
calculated according to the measured actual length. In
this case, the adjusted value is 47 mm.
Press the default key to cancel the readout adjustment.
w Default key
67