Table of Contents
Advertisement
Installation Step 8 - Plug In Your Water Ionizer:
A.) Confirm that the power outlet is a 110 V/60Hz and grounded
BEFORE plugging in your water ionizer.
B. When you first plug the unit in, a water indicator, e.g., "Daily Drinking,"
will light. The LCD will not display, however, until water is flowing into the
unit. So, if you have not already done so, be sure you've switched on the
Faucet Diverter Valve and water is flowing into the unit.
pH Presets:
1. Factory pH Value Presets - Your water ionizer's primary pH settings
are preset at the factory within the following ranges.
Alkaline Water Presets:
COOKING
MAKE TEA &
COFFEE
DAILY DRINKING
INITIAL DRINKING
2. Impact of environmental & other factors on pH - However ,
differential regional, environmental and testing factors such as the
quality, pH level, Total Dissolved Solids (TDS) and temperature of the
source water as well as the flow rate through the water ionizer can all
cause variations in the pH level of the water dispensed from your
water ionizer. For example, the above referenced pH preset values
were derived from 68°-77° F (20°-25° C) source water with a neutral
pH of approx 7.0 containing 100 - 150 parts per million of Total
Dissolved Solids (TDS) flowing at 2L (0.5 gal) per minute.
22
22
-When the Set light comes on it is time to change the filter.
-After you change the filter just hold down the SET button
for 10 Seconds until the Set light turns off.
NOTE: The Liter counter will not reset.
= 9.5 - 11.0 pH
= 9.5 - 10.0 pH
= 8.5 - 9.5 pH
= 7.5 - 8.5 pH
NEED HELP CALL 1-888-601-5886
Filtered Water Preset:
PURIFIED WATER
(Most Municipal Tap Water is 7.0 pH)
Acidic Water Presets:
= 6.0 - 7.0 pH
CLEANING
= 5.5 - 6.5 pH
CLEANING
Same pH as
=
Source W
ater
Advertisement
Table of Contents
