Table of Contents
Advertisement
Installation Step 5a
(special) Connect the inlet and acid water hoses to the
faucet diverter Valve:
There are two (2) post hose connectors for the hoses on the faucet diverter Valve.
The 'top' barbed post connector is for outgoing water which when diverted with the
control handle will flow into the water "in" port on the bottom right side of the unit
(control panel facing you). This is called your 'supply line'.
The 'bottom' connector is for the 'acidic' 'out-line' from the left bottom of the unit
(control panel facing you) this 'out-line' allows the acidic water to flow out of the
small spigot next to the larger spigot (normal water flow is from the larger spigot).
This diverter when attached to the faucet end provides alkaline water when the
diverter is activated or normal tap water if the diverter is set for tap water.
In order to attach either hose to the top or bottom connector the hose must be 'slid'
onto the Diverter about 1/2 inch. You can also use a few drops of water inside
the hose to help "slide" the hose onto the connector.
Inlet Water Hose
On Top ( Connect to
power cord side)
Acidic Water Outlet Tube
On the Bottom
19
NEED HELP CALL 1-888-601-5886
Advertisement
Table of Contents
