Installing
4.5 Mounting the motor
1505
1555
1556
Figure 4-4
Procedure
1. Fit the coupling half 1556 onto the motor shaft extension. See Mounting an input or output
element on the gearbox shaft (Page 25).
2. Maintain the clearances z12 and z.
3. Apply adhesive (medium strength, for example Loctite 243) to the grub screw 1564.
4. Tighten the grub screw 1564 to the specified torque T
5. On motors balanced with half a feather key (code "H"), remove projecting, visible parts of
the feather key.
6. Place the flexible element 1557 inside the coupling half 1555.
7. Apply adhesive (medium strength, for example Loctite 243) to the bolts 1505.
8. Fasten the motor with the bolts 1505 with the prescribed torque. See Thread sizes and
tightening torques for fastening bolts (Page 25).
You have mounted the standard motor on the K2 adapter.
32
Bolt
Coupling half
Coupling half
Adapter K2
1557
Flexible element
1564
Grub screw
SW and across-flats dimension SW.
A
Operating Instructions, 12/2022, A5E50009089A/RS-AJ
BA 2039 (2KJ4)