Siemens SIMOGEAR BA 2039 Operating Instructions Manual page 32

Installing
4.5 Mounting the motor
Size KS3 to KS10
1
1505
1555
Figure 4-3
Procedure
1. Loosen the bolt 1 slightly.
2. Fit the coupling half 1556 onto the motor shaft extension. See Mounting an input or output
element on the gearbox shaft (Page 25).
3. Maintain the clearances z12 and z.
4. Apply adhesive (medium strength, for example Loctite 243) to the bolt 1.
5. Tighten bolt 1 with the specified torque T
In the case of 2 bolts, tighten both alternately in equal steps with the specified tightening
torques.
6. Insert the elastomer 1557 in the already assembled coupling half 1556 on the motor shaft
extension.
7. Lightly grease or oil the tooth flanks to reduce the mounting force.
8. Apply adhesive (medium strength, for example Loctite 243) to the bolts 1505.
9. Fasten the motor with the bolts 1505 with the prescribed torque. See Thread sizes and
tightening torques for fastening bolts (Page 25).
The claws of the coupling parts must interlock.
You have mounted the SIEMENS servomotor on the KS adapter.
30
Bolt
Bolt
Coupling half
Adapter KS
1556 Coupling half
1557 Elastomer
SW.
A
Operating Instructions, 12/2022, A5E50009089A/RS-AJ
BA 2039 (2KJ4)