Mounting The Motor - Siemens SIMOGEAR BA 2039 Operating Instructions Manual

Observe the correct mounting arrangement to minimize stress on shafts and bearings due to
lateral forces.
Correct
a
F
Figure 4-2
Procedure
1. Use either benzine or solvent to remove the anti-corrosion protection from the shaft
extensions and flanges or remove the applied protective skin.
2. Fit the drive input and output elements to the shafts. Fasten the elements when necessary.
You have now fitted the input or output element.
4.5

Mounting the motor

NOTICE
Moisture penetrates an inadequately sealed geared motor
If the geared motor is to be installed outdoors or for an installation requiring a high degree
of protection (≥ IP55):
• Seal the flange, bolts 1505 or integrated elements such as proximity switches, using an
• The flange-mounted motor must be sealed across the entire contact surface.
• Seal the geared motor in the outer area.
Note
The flange-mounted motor must always be sealed using a suitable sealing compound.
BA 2039 (2KJ4)
Operating Instructions, 12/2022, A5E50009089A/RS-AJ
Hub
Force
Mounting arrangement for low stress on shafts and bearings
appropriate sealing compound.
Incorrect
Installing
4.5 Mounting the motor
27