Renesas RA Family
5.1.1.3 Option 4: 5V Test Points
5 V may be supplied from an external power supply to test points on the board. TP7 (5 V) and TP9 (GND)
are loop-style test points, and J60 provides large via style test points that can accommodate a 0.1" pin
header or connector. The two types of test points are electrically equivalent, and both are provided for user
convenience. Power from this source is connected to the main system 5 V power. Reverse current protection
is provided between the 5 V test points and the main system 5 V power. TP7 (5 V), TP9 (GND) and J60 can
be found at the top left of the board above Pmod1.
5.1.2 Power Supply Considerations
The on-board LDO regulator which supplies +3.3 V has a built-in current limit of 2.0 A. Make sure the total
current required by the RA MCU, any active on-board features, and any connected peripheral devices does
not exceed this limit.
Note: The total current available from a typical enumerated USB host is 500 mA maximum. Depending on
the configuration of the kit, multiple power sources may be required.
5.1.3 Power-up Behavior
When powered, the white LED near the center of the board (the "dash" in the EK-RA8M1 name) will light up.
For more details on initial power up behavior, see the EK-RA8M1 Quick Start Guide.
5.2 Debug and Trace
The EK-RA8M1 board supports the following three debug modes.
Table 3. Debug Modes
Debug Modes
Debug MCU
(the device that
connects to the
IDE on PC)
Debug on-board
J-Link On Board
(on-board)
Debug in
External
debugging tools
Debug out
J-Link On Board
(on-board)
Notes:
•
See Table 5 for the Debug USB connector pin definition.
•
See Table 8 for the 20-pin JTAG connector pin definition.
•
See Table 9 for the 10-pin JTAG connector pin definition.
R20UT5149EG0100 Rev 1.00
Oct.03.23
Figure 9. Test Point Location
Target MCU
Debugging
Interface/Protocol
(the device that
is being
debugged)
RA8M1
SWD
(on-board)
RA8M1
SWD, ETM, JTAG
(on-board)
Any external RA
SWD
MCU
EK-RA8M1 v1 – User's Manual
Connector Used
Micro USB (J10)
20-pin connector (J20) or
10-pin connector (J13)
Micro USB (J10) plus either
20-pin connector (J20) or
10-pin connector (J13)
Page 17 of 37