Ariston benchmark GENUS HE SYSTEM User Manual page 12

User's manual
Set fixed flow temperature on the heating zone
The parameter is used to modify the heating flow temperature if the
temperature regulation at a fixed value is activated.
The temperature of Zone 1 and Zone  (if present) may be adjusted.
To modify the temperature set, proceed as follow:
- press the M / button, the display will flash
enu ok
- turn the CH knob
Parameters"
- press the M /o button to access the sub-menu, the display
enu k
will flash - "Set points"
00
- press the M /o button to access the parameters, the display
enu k
will flash 400
- turn the CH knob to select the parameter
- "FIX Temp"
- turn the CH knob to select the new temperature;
- press the M /o button to confirm
enu k
- press the e button to restore the normal display screen.
sc
To set the Fixed temperature - heating zone  (if present) proceed
as Heating Zone 1, selecting menu 5.
1
000
to select the menu400
402
INFO ( ) - display only
- accessed by pressing the button
- "Zone1
If the I button is pressed, a menu is accessed which enables the
nfo
data listed in the table below to be displayed.
The display scrolls through various information when the CH knob
is turned.
Press the Esc button to restore the normal display screen.
Informations displayed
Time of day - Hour
Heating circuit pressure (bar)
External temperature (°C)
-only with external sensor connected
Room temperature (°C)
- only active when the BUS device is connected
D.H.W. Flow rate (l/m)
Set C.H. temperature (°C)
Set D.H.W. temperature (°C)
Month until next maintenance
Technical Assistance Centre telephone number and name
(only display if setted parameters 890 - 891)
D.H.W. comfort temperature (°C) - if activated
AUTO Function
"enabled" or "disabled"
Storage temperature °C
only for boiler with storage tank
Inverno