Fill Up And Start-Up Instructions; Filling The Spa With Water; Applying Power - Fantasy Spas Aspire Owner's Manual

FILL UP AND START-UP INSTRUCTIONS

The following procedures should be followed on
initial startup and whenever the spa is drained for
routine maintenance.
FILLING THE SPA WITH
WATER
1. Clear all the debris from your spa.
2. Verify Drain cap is attached and tight.
3. Be sure to open all jets to allow as much air as
possible to escape from the plumbing during
the filling process.
4. Insert a garden hose into filter compartment to
fill your spa.
NOTE: Do not use hot or softened water.
5. As the water level rises, check inside the
equipment compartment for water leaks. It may
be necessary to tighten unions and/or fittings
that may have loosened during delivery. There
is no need to call for service; this can easily be
done. If assistance is required, contact your
local Dealer.
15
UNIONS
For further inquiries, please contact our Customer Service Team
Email: ahsservice@watkinsmfg.com
6. Under normal circumstances keep the water
level half way between the top of the spa and
the top of the gray filter ring or just above the
highest jets (whichever is higher).
Failure to keep enough water in your spa may
result in damage to your system and invalidate
your warranty. If your spa filter is sucking in air
causing the pump to cavitate, you need to add
water!
IMPORTANT: Loosen drain cap and allow
water to exit hose bib for 5 seconds to help
prime the jet pump, then tighten drain cap. If
the jet pump still is not primed after running
repeat step.
7. Check the filter installation and make sure the
filter is not loose.

APPLYING POWER

1. Turn power to spa "ON" (after filling spa) from
the main panel at the house and the subpanel.
2. Press the Jets button on the topside control
panel to activate the spa. Rotate all the air
control valves counterclockwise and observe
the increased jet action (air mixed with water).
3. While the pump is running check again for
water leaks at the drain, unions, or fittings in
the equipment compartment (leaks may have
occurred during transit). If water is leaking from
one of these areas, there is no need to call for
service. Simply tighten the fitting. If assistance
is required, contact your local Dealer
4. After checking your spa for leaks it is now time
to adjust your spa settings. Press the Up or
Down button on your topside control panel until
the display indicates your desired temperature
is set.
Phone: 888-961-7727